Test fitting the leading edge...

Making cable ends for the tail supports.

The leading edge, gusseted aileron.

Putting the leading edge ply on the ailerons. I'm letting it go past an inch on both sides and then cutting it back into gussets...

Had to make one nose rib double-wide and out of line to seam my leading edge ply on.

Nose ribs all glued.

.8mm ply being "trained" to wrap the leading edge

I'm back to building! Got everything done on both wings except strut and root fittings and leading edges.

Tail wheel, hoping its not too heavy after the control arms are added.

Rudder hinged

Those hinge pins and bolt will be replaced with the correct sizes.

Outer hinge block for wing 2

Weighing the honcho wings for a comparison...

Hinge blocks and leading edge ribs

We have clean separation!

Diagonal bracing in aileron 2!

Wing 2, Aileron 2

Trailing edge complete!

Glueing the bottom of the trailing edge.

Hardware! Now I can get back to work.

Tail cable fasteners!

Diagonal bracing all glued in!

Wing one is on the wall, and wing two is taking shape on the table...